Interesting Instructables and comments for the vertical-axis wind turbines that one Faroun is developing. Here’s his latest progress, based on 4″ PVC pipe for the blades:
Check out 4 more turbine designs by the same user here. Things get a bit wobbly at the end, but much healthy progress with an admirably low cost setup!
4 thoughts on “Faroun’s Evolving Turbine Designs”
Comments are closed.
ADVERTISEMENT
Support Make:
Join Make: Community Today
Join Make: Community Today
Could the wobbliness be corrected by laying it side and supported equally on both ends? Would being on its side effect the spin?
I wish this guy would measure some form of output for his models.