Find all your DIY electronics in the MakerShed. 3D Printing, Kits, Arduino, Raspberry Pi, Books & more!

4282126305 36A8C71944 O
4284839289 3F96851651 O
Nice homemade back-of-iMac shelf solution, I’m sure this will be a product soon :)

Dylan writes -

5″ x 8″ x 1/2″ oak cut at an angle to match the slant of the iMac stand. Drilled all the way through 1″ from edges at 1/4″ diameter. 17″ x 1/4″ steel rod bent into “U” shape with brake line (rubber hose) fit on flat edge to provide grip and protection. Tapped the ends at 1/4 x 20 and fit regular bolts on the end for now. Will put wing nuts on at later time for easier adjustment, though can be adjusted to fit at any point on stand with a wrench. Would also like to add small cable spool to the underside to provide better cable management. 

Phillip Torrone

Editor at large – Make magazine. Creative director – Adafruit Industries, contributing editor – Popular Science. Previously: Founded – Hack-a-Day, how-to editor – Engadget, Director of product development – Fallon Worldwide, Technology Director – Braincraft.


Related
blog comments powered by Disqus

Featured Products from the MakerShed