Arduino Nerf sentry gun build: Soldering the relay

Arduino Technology
Arduino Nerf sentry gun build: Soldering the relay

The next step in making my autonomous Arduino Nerf sentry gun is to move the relay circuit from the temporary breadboard onto something more durable and permanent, yet easy to connect. Wires from the Arduino and the trigger switch jack will need to connect through the relay board.

sentryRelaySoldered01.jpg
I soldered the relay, diode and some screw terminal connectors onto a piece of perfboard. I connected the appropriate leads using small bits of wire I’d snipped off of some LEDs for a previous project. One hilarious/awful bit of troubleshooting I had to do was due to a hidden connection between every three pads on my original perfboard. Once I realized what was going on, I re-soldered things onto a more appropriate board.

Finally, I wired up the relay coil terminals to open and close from a timed test sketch on an Arduino. When the coils were energized, my multimeter beeped to indicate the closing of the switch. This is exactly what will need to happen to fire the Nerf gun.

sentryRelaySoldered02.jpg

In the Maker Shed:

Makershedsmall

arduino_duemilanove_cropped.jpg

Arduino Duemilanove

Discuss this article with the rest of the community on our Discord server!
Tagged

John Edgar Park likes to make things and tell people about it. He builds project for Adafruit Industries. You can find him at jpixl.net and twitter/IG @johnedgarpark

View more articles by John Edgar Park

ADVERTISEMENT

Maker Faire Bay Area 2023 - Mare Island, CA

Escape to an island of imagination + innovation as Maker Faire Bay Area returns for its 15th iteration!

Buy Tickets today! SAVE 15% and lock-in your preferred date(s).

FEEDBACK