Find all your DIY electronics in the MakerShed. 3D Printing, Kits, Arduino, Raspberry Pi, Books & more!

Our friends Lenore and Windell created an attachment to engrave glass, stone, and ceramic with an Eggbot.

The engraving tip itself is a small single-point industrial diamond, mounted on a thin steel shaft, in a fixture that holds it where the pen would normally be. That fixture consists of a 3/8-16 nylon thumb screw, drilled out to fit the steel shaft, and a matching 3/8-16 hex nut that locks it in place.

John Baichtal

My interests include writing, electronics, RPGs, scifi, hackers & hackerspaces, 3D printing, building sets & toys. @johnbaichtal nerdage.net


Related

Comments

  1. Bryan says:

    Hmmm… I wonder if a similar attachment could be used on a pen plotter to engrave circuit boards?

In the Maker Shed