Solder Stencils via Electronic Craft Cutter

Technology
Solder Stencils via Electronic Craft Cutter

Solder stencil cut using Craft Robo cutting plotter

Spotted in the MAKE Flickr pool, some interesting process shots from user Shigeru Kanemoto, who’s used a Craft ROBO brand paper-cutting robot to prepare a stencil for applying solder paste to a PCB in preparation for SMT assembly. Uppermost, the stencil freshly cut; immediately above, solder paste applied. Cool idea, with a few more shots in Shigeru-san’s photostream.

16 thoughts on “Solder Stencils via Electronic Craft Cutter

  1. Salman Sheikh says:

    This is awesome because many of the stencil companies are too expensive for the average maker to go spend a lot just for the stencils that maybe one time usage for making a pcb.

  2. Tom Lynch says:

    The big issue with the craft robo is the cost, it it uses a carrier sheet to hold the paper while cutting so that the material that is cut out doesn’t curl up into the machine or tear. These sheets cost a fortune and can only be used a handful of times.

    I have had some success which affixing paper to card with photo/spray mount however that leaves a residue on the paper you want to cut which is not ideal.

    It would be good if someone could figure out a good solution to holding the paper down, when cutting, perhaps a suction air bed?

    1. Jason King says:

      Tom,
      I have a Silhouette SD and make cheap replacement carriers by buying a three-pack of roll-up cutting boards from a dollar store and spraying them with 3M 2-way glue. If you let it dry for five to ten minutes before affixing the paper to it, it shouldn’t leave a residue (only ever had problems when attempting to cut construction paper). Keep it covered with a piece of wax paper between uses so that the adhesive doesn’t lose too much of it’s tackiness.

      Hope this helps.

    2. Jason King says:

      Alternatively, if you are cutting relatively small features in a sheet, you can load the paper without a carrier in media mode.

  3. Kevin Gunn says:

    It’s a pretty stencil, but I fear it is way too thick.  I’m working with kapton because its is thin enough to lay down the proper amount of solder paste, but cutting it with my laser is proving a bit difficult for smaller parts.  If anyone uses one of these stencils, please post your results in terms of paste quantity!  Do you get bridging due to excessive solder?

    1. Anonymous says:

      I agree with the thickness, but it might be possible to make the holes smaller. Instead of a flat, thin layer you have a skinny, tall layer. That might be “close enough” to the real thing.

  4. John Fullerton says:

    That is slick as catshit.

  5. John Fullerton says:

    That is slick as catshit.

Comments are closed.

Discuss this article with the rest of the community on our Discord server!
Tagged

I am descended from 5,000 generations of tool-using primates. Also, I went to college and stuff. I am a long-time contributor to MAKE magazine and makezine.com. My work has also appeared in ReadyMade, c't – Magazin für Computertechnik, and The Wall Street Journal.

View more articles by Sean Michael Ragan

ADVERTISEMENT

Maker Faire Bay Area 2023 - Mare Island, CA

Escape to an island of imagination + innovation as Maker Faire Bay Area returns for its 15th iteration!

Buy Tickets today! SAVE 15% and lock-in your preferred date(s).

FEEDBACK