Find all your DIY electronics in the MakerShed. 3D Printing, Kits, Arduino, Raspberry Pi, Books & more!

cnc milled finger joint arduino motion light Low Power RGB Night Light
Michael of n0m1 Design built this Arduino-controlled night light as a Mother’s Day gift.

A few years back I made a motion sensitive night light as a Mother’s day gift and while it worked pretty well it really chewed out the batteries. And as with all devices that eat batteries it eventually fell out of use. The standby current was around 4 mA due to the common LM324 opamp that was used to amplify the PIR motion sensor signal. The original enclosure was CNC milled from a bit of re-purposed apple which had a former life as a guitar body I built as a child.

Code and schematics on the project page.

John Baichtal

My interests include writing, electronics, RPGs, scifi, hackers & hackerspaces, 3D printing, building sets & toys. @johnbaichtal nerdage.net


Related
blog comments powered by Disqus

Related Supplies at Maker Shed

Follow

Get every new post delivered to your Inbox.

Join 26,253 other followers