Find all your DIY electronics in the MakerShed. 3D Printing, Kits, Arduino, Raspberry Pi, Books & more!

Earlier this month, we linked out to the first three posts in the I Heart Robotics team’s ongoing series about choosing hardware for the fused-filament parts that come off your RepRap-type 3D printer. On Sunday, they published the fourth installment, this time focusing on the best way to make a rotating pin joint between two printed beams, for instance in the “knee” of a robot leg. They experiment with various configurations of pop rivets, tubular rivets, flat washers, spring washers, clevis pins, and E-rings. Click through, below, to check out their results.

Fasteners for 3D Printing: Tenacity and robust pin joints. Part 4 of n

Sean Michael Ragan

I am descended from 5,000 generations of tool-using primates. Also, I went to college and stuff. I write for MAKE, serve as Technical Editor for MAKE magazine, and develop original DIY content for Make: Projects.


Related
blog comments powered by Disqus

Featured Products from the MakerShed

Follow

Get every new post delivered to your Inbox.

Join 25,442 other followers