» MAKE: NOISE — Discuss this article

Showing messages 1 through 2 of 2.

• Button connection
  You must be logged in to reply.
  
  
  I am building this puzzle box but I have a few questions. On the block diagram Fig.1 drawing of connections there is a dotted line from the button to the pololu digital switch.Where on the pololu digital switch does it go to? Also do the numbers next to the components have a reference? I can't find any but I'm sure it's out there somewhere. Also are the pin numbers from a component to the "daughter" card, or from the component to the Arduino board? IE GPS has pins 2,3,GND, and +5, are those connections that eventually go to the Arduino Via the Daughter board. Also the Drawing of the lighted pushbutton has only 4 connections, and the button actually has 5 connections. NO1, NC1, C1, +, and -. The only wire I have no connection for is the NC1. is that the one that goes to the Shield? Sorry about all the questions, but I'n new to this.
  
  Thanks
  Kim

  Posted by uneakone on March 13, 2011 at 14:01:20 Pacific Time

• conversion to miles and feet
  You must be logged in to reply.
  
  
  OK, I have all the electronics put together and it works great.(now I have to find a really cool box for it) I was wondering however if there is a not too complicated way to display "Miles" or "Feet" instead of "m" or "Km".
  
  Kim

  Posted by uneakone on March 15, 2011 at 18:06:12 Pacific Time