HOW TO – Using IR modules from VCRs

HOW TO – Using IR modules from VCRs

Panel ThProcure IR modules from an old VCR, Raphael writes “Some time ago, I came across the Lirc (Linux Infrared Remote Control) website and decided to build a serial port IR receiver. They had a list of suggested IR receiver modules, but I was unable to buy one, so I had to think of using something else. A IR Receiver module is usually a photodiode and a 38khz detector. Most of them have 3 pins. VCC, GND, an output pin. If a 38khz carrier is detected, the output pin will become active. Some modules are active low, and others are active high. It is sometimes required to use an inverter(eg: 7404) to get the correct signal.” Link.

Discuss this article with the rest of the community on our Discord server!
Tagged

current: @adafruit - previous: MAKE, popular science, hackaday, engadget, fallon, braincraft ... howtoons, 2600...

View more articles by Phillip Torrone

ADVERTISEMENT

Maker Faire Bay Area 2023 - Mare Island, CA

Escape to an island of imagination + innovation as Maker Faire Bay Area returns for its 15th iteration!

Buy Tickets today! SAVE 15% and lock-in your preferred date(s).

FEEDBACK