Find all your DIY electronics in the MakerShed. 3D Printing, Kits, Arduino, Raspberry Pi, Books & more!

stay tab shade lamps comparison on off Pull Tab Lampshade

Sean Ragan made this lampshade from soda pull tabs, interlocking them in an interesting way:

Careful study of the photograph will probably tell you all you need to know about the chaining technique. Each tab is bent to approximately 120 degrees and then snipped at the top. The top loop of the tab is then threaded through the bottom loops of two adjacent tabs on the row above. Rinse and repeat to create mail.

From the pages of CRAFT, Vol. 03:

craft03 pulltabcrochet Pull Tab Lampshade“Pull-Tab Crochet,” by the designers of Escama, pgs 118-119. Buy the back issue in the Maker Shed.

becky stern headshot Pull Tab Lampshade

Becky Stern

Becky Stern is director of wearable electronics at Adafruit Industries. Her personal site: sternlab.org


Related
blog comments powered by Disqus
Follow

Get every new post delivered to your Inbox.

Join 26,240 other followers