Find all your DIY electronics in the MakerShed. 3D Printing, Kits, Arduino, Raspberry Pi, Books & more!
CEB Shaker Hydraulics Assembly

Additional Materials Required:

  • Thread tape
  • Shaker motor Buy
  • 1/2" NPT Needle Valve (1) Buy
  • 1/4"x12" NPTM Hydraulic hose (1)Buy
  • 1/2"x36" NPTM Hydraulic hoses (2)
  • SAE 4M to 1/4" NPTF Swivel (1)Buy
  • 1/2" NPT Hex Nipple (2) Buy
  • 1/2" NPTF Tee (1) Buy
  • 1/2" NPTM to 1/4" NPTF bushing Buy
Related

Steps

Step #1: Things to know about working with hydraulics:

PrevNext
  • Thread tape is necessary between each connection unless otherwise stated.
  • Always wrap thread tape clockwise when facing the threaded portion.
  • Always keep the end caps on hoses and fittings until you need to take them off. They need to stay protected inside.

Step #2:

PrevNext
CEB Shaker Hydraulics AssemblyCEB Shaker Hydraulics AssemblyCEB Shaker Hydraulics Assembly
  • Attach all of the fittings and the 2 hoses to the Tee, except the small swivel.
  • Tighten the tee assembly into the correct port (see the photo)
  • Install the swivel and tighten the small hose to it.
  • The swivel doesn't need thread tape.
  • Put the other 36" hose into the remaining port on the motor.

blog comments powered by Disqus

Related Supplies at Maker Shed

Follow

Get every new post delivered to your Inbox.

Join 26,173 other followers