Find all your DIY electronics in the MakerShed. 3D Printing, Kits, Arduino, Raspberry Pi, Books & more!

Steps

Step #1:

PrevNext
Rubber Band Gun
  • You will need a hammer,
  • wire snips,
  • wood your desired size about 1cm thick and about 10 cm across,
  • elastic bands 3>,
  • 1cm nails.

Step #2:

PrevNext
Rubber Band Gun

Hammer one nail about 1cm in.

Step #3:

PrevNext
Rubber Band Gun

Then hammer another nail on the opposite side on the other end as pictured.

Step #4:

PrevNext
Rubber Band GunRubber Band GunRubber Band Gun

Some more views of it.

Step #5:

PrevNext
Rubber Band GunRubber Band GunRubber Band Gun
  • Lay pieces out like this.
  • Hold them together with elastic bands (2 or more).

Step #6:

PrevNext
Rubber Band GunRubber Band GunRubber Band Gun
  • Just snip the nail down a bit for more reliability.
  • Pop a rubber band over the nail at the top then tuck it in the gap between the two bits of wood.

Step #7:

PrevNext
Rubber Band Gun

Have fun!!!

Conclusion

Get ready for a mission!!!


blog comments powered by Disqus

Related Supplies at Maker Shed

Follow

Get every new post delivered to your Inbox.

Join 26,184 other followers