Craft & Design
Pear light

153405 Dr6Ngfye8Ei1Is8O5Kdx1Fmme
Nick Foley’s gorgeous pear light…

A hand forged hollow steel tree is the charging station for three urethane pear-lights. Each pear contains ten ultrabright white LEDs, an autonomous charging circuit, and rare-earth magnets that allow it to be “picked” from the tree and remain fully illuminated for over an hour

Pear light – Link.

8 thoughts on “Pear light

  1. If i were designing it, charging would be simple…

    each “pear’s” “stem” would consist of a ring enclosing a circle(imagine a bullseye-style target) the center would be a magnet (or simply a piece of ferrous material), which acts as (or is surrounded by) the positive contact. the ring would be a non-ferrous ground contact. The tree would have matching sets of these tip-ring style connectors for the pears to charge at….

    however, if they wanted to be complicated, they could use an electric toothbrush style induction charger.

  2. Hey – thanks for the interest.

    The pears charge by having a set of copper contacts where the “stem” would be. On the pear, they appear as a series of copper dots that are flush with the surface. On the tree, springloaded tabs make sure you get a solid electrical connection no matter how you place the pear on the tree.

Comments are closed.

Tagged

current: @adafruit - previous: MAKE, popular science, hackaday, engadget, fallon, braincraft ... howtoons, 2600...

View more articles by Phillip Torrone