Life clock

Craft & Design
Life clock

The Life clock, by Bertrand Planes runs on a “clock mechanism slowed down 61320 times” so that each number represents years. – Link

Marco writes in asking – “How does one make one of these?”
Well, besides having highly reliable components – I’d imagine the clock hands could be animated by stepper motors which in turn are driven by a microcontroller/realtime clock . . . hmm, any readers care to step in here?

This might come in handy, for starters:


Relatime clock module with calendar accurate up to year 2100 – Link


Clock of the long now from Bay Area Maker Faire ’07 – Link

From the Maker store:

LED Clock kit – Link

16 thoughts on “Life clock

  1. PattiS says:

    He’s not a Spinal Tap kinda guy, is he. My clock would go to 110, at least!

  2. kyle says:

    Stepper motors would probably be the best way to go about this. I’m assuming the minute hand represents how far through the year it is and the hour hand represents the year. So, each tick would be a little less than a week. I would use a little AVR to control the stepper motors and a real-time clock to keep track of the time. The battery that comes with the RTC above should be enough to keep the clock running during a power outage. Sounds like a fun project!

  3. kyle says:

    Here’s a good instructable on how to control stepper motors from an AVR:

  4. John Honniball says:

    Clocks like this are driven by a type of stepper motor that steps every time the clock ticks. You’ll see it better on a clock with a seconds hand, but the principle is to divide down a quartz crystal to 1Hz and then drive the motor with that. If you replace the original driver (usually a chip-on-board “blob”) with a microcontroller, you can have the clock go as slow as you like, and probably quite a bit faster than real-time.

  5. macegr says:

    My concern would be accidental jostling or a small mechanical problem that possibly prevents the hands from moving every couple months…that would be hard to detect, but would add up. Some type of feedback mechanism could help. Also, it would require a lot of thought to build something that would actually last that many years. As an example of the problems faced, microcontroller Flash memory is typically rated to retain programming for only 20 years. Crystal oscillators also degrade with age. The best solution I can imagine would be a very robust dry-lubed mechanical device with a simple 1PPS interface, so that you can always rebuild a controller that can get the current atomic clock time and activate the clock, regardless of the technology available.

  6. Ken says:

    This clock is completely depressing. When I think about where the hands would be on MY clock, I can’t help but shudder.

  7. The Oracle says:

    That was my first thought too Ken. This is a depressing project.

  8. Hannes says:

    Didn’t I see this on SkyMaul before?

Comments are closed.

Discuss this article with the rest of the community on our Discord server!


Ready to dive into the realm of hands-on innovation? This collection serves as your passport to an exhilarating journey of cutting-edge tinkering and technological marvels, encompassing 15 indispensable books tailored for budding creators.

Escape to an island of imagination + innovation as Maker Faire Bay Area returns for its 15th iteration!

Buy Tickets today! SAVE 15% and lock-in your preferred date(s).