Find all your DIY electronics in the MakerShed. 3D Printing, Kits, Arduino, Raspberry Pi, Books & more!

Fkhwm5Qf04Fmxdx.Medium
Hilarycheng writes -

There are lots of people mentioned about using Inkjet Glossy Paper to do Toner Transfer. It can be done. But it is not easy to remove it after ironing. You have soak the PCB in hot water for more than ten minutes. It is quite time consuming. If you cannot remove the coating completely. It cannot be etched.

I have tried to use Konica Minolta Photo Quailty Matte Paper. Then design your own circuit and print it on the Matte Paper. Remember, before printing it. You need to mirror board. Otherwise, the circuit will be inversed.

Cheap and easy toner transfer for PCB making – Link.

Related:

  • HOW TO – Direct to PCB ink jet resist printing – Link.
  • Two sided PCB using toner method – Link.
  • Making PCBs @ MAKE – Link.

From the pages of MAKE:
Make 495

Printed Circuit Boards. Step-by-step instructions for making your own PCBs at home. MAKE 02 – page 164. Subscribers–read this article now in your digital edition or get MAKE 02 @ the Maker store.

Phillip Torrone

Editor at large – Make magazine. Creative director – Adafruit Industries, contributing editor – Popular Science. Previously: Founded – Hack-a-Day, how-to editor – Engadget, Director of product development – Fallon Worldwide, Technology Director – Braincraft.


Related
blog comments powered by Disqus

Featured Products from the MakerShed

Follow

Get every new post delivered to your Inbox.

Join 25,788 other followers