Find all your DIY electronics in the MakerShed. 3D Printing, Kits, Arduino, Raspberry Pi, Books & more!

countersink1 Quick n Dirty: Countersink

Maker extraordinaire Craig Smith shared another quick work tip with us:

Sometimes I grab the cordless drill/driver, some screws, and perhaps a small pilot drill bit on a quick construction/repair project. The screws would be better if they were 100% flush and I didn’t grab a countersink bit, or perhaps I’m at a location without a countersink bit available. If I have a regular 3/8″ drill bit I can slightly (and carefully) drill a countersink divot. But often I just use the spinning Phillips head driver bit and swing the drill in a circular motion around the hole at an angle a few times to create a countersink area before I zip the screw in. A recommended countersink method… no. In a pinch where it needs to be done… yes.

See all of Craig Smith’s tips and projects.

Gareth Branwyn

Gareth Branwyn is a freelancer writer and the former Editorial Director of Maker Media. He is the author or editor of a dozen books on technology, DIY, and geek culture, including the first book about the web (Mosaic Quick Tour) and the Absolute Beginner’s Guide to Building Robots. He is currently working on a best-of collection of his writing, called Borg Like Me.


Related
blog comments powered by Disqus

Related Supplies at Maker Shed

Follow

Get every new post delivered to your Inbox.

Join 26,178 other followers