I took the build list to RadioShack and a sales rep helped me find all the parts. When I got ready to build the amp I practiced my soldering skills on a circuit board out of a dead appliance then went to work. Once the circuit was all soldered and checked with a magnifying glass I added power and it worked immediately. I used a speaker out of an old TV. I also chose to add a switch and LED so I wouldn’t forget to stop the power when done using it. I ended up installing the setup in an old Christmas cookie tin that I have had in my shed for years. I always loved the tin and was pleased to find that it could be put to a better purpose. I marked out the speaker hole, drilled a hole in the corner, then cut the first L corner with a sharp knife. I then used tin snips to finish the job. I split some old medical oxygen tubing to go over the sharp edges then found old mesh wire to go over the opening. I cut the mesh to size and bent all the wire ends down, then marked a spot to drill a tiny hole for each wire. The mesh was then placed on and the wires were bent over on the inside. I next drilled holes for the speaker lugs, switch, light, and input jack. Once all the components were installed I attached the circuit board in the tin with double back tape. I placed a little batting in behind the speaker and then cut the foam for the battery and threaded the battery lead up through the foam. The project is beautiful, and sounds great.
Sign up below for the Weekend Projects Newsletter to receive the projects before anybody else does, get tips, see other makers’ builds, and more.
See all of the Weekend Projects posts