Subscribe to Make Magazine Today!

CRAFT: Crafty Travels
wickinghouseplants.jpg
My friend Goli recently went on a solo backpacking trip. When she returned she discovered that an unexpected heat wave had taken a toll on some of her plants. I volunteered to show her two very simple ways to keep her houseplants watered while she’s off on her adventures. Cotton strips buried in the soil of each plant slowly wick water, keeping the root zone moist without leaving them soaked. A crafty little setup like this is super easy, and it’s way cheaper than a house sitter!
Setting your plant directly into a tray of water might seem like a good solution when you are out of town, but that technique can easily “drown” the roots. Roots love oxygen, so sopping wet soil can cause rot, mold, and infection to set in. Using a simple wicking system means the dirt will have just the right amount of moisture. But always choose cotton — polyester just won’t work the same.


wickinghouseplants_materials.jpg

Materials

Cotton fabric
Scissors
Houseplants

Large bowl of water taller than the plant’s container
Small bowl of water smaller than your plant’s container

Directions

Prepare the wicks:
Cut the cotton fabric into strips 1″ wide, about 12″ long.
wickingplants_step1.jpg

Method One

Step 1: Lay one end of the cotton strip on the soil. Wrap it loosely around the base of the plant’s stem.
wickingplants_step2.jpg
wickingplants_step2b.jpg
Step 2: Use your finger to gently dig into the soil of the first plant. Try not to disturb the roots. Bury the end of the cotton strip in the dirt.
wickingplants_step3.jpg
wickingplants_step3b.jpg
Step 3: Fill the tall, large bowl with water, and set it next to the plant. Place the other end of the cotton strip in the bowl of water. Be sure that the strip increases elevation as it spans between the plant and the container of water. The water will slowly wick over, from the bowl to the soil, via the cotton.
wickingplant_step4.jpg

Method Two

Step 1: Wrap the wick loosely around the base of the plant, and bury its end in the dirt.
wickingplants_step5.jpg
Step 2: Place the free end of the wick in a bowl of water that is a tiny bit smaller than the width of the plant’s pot.
wickingplants_step6.jpg
Step 3: Set the plant’s pot in the bowl of water. You want the plant to rest in the bowl, but with a reservoir of water beneath it. The water will wick up through the cotton from the bowl of water under the plant.


  • mohamed uzail

    pleace my dear.
    I need your help on my home gerdan

  • jessica

    thanx!!!! this really helpedme

  • Tori

    Does the method you use make any difference?

  • http://the-refill.com/2014/08/10/5-clever-tips-for-travel-in-japan/ 5 Clever Tips for Travel in Japan | the refill

    […] Lastly, if you’re worried about leaving your delicate plants to the ravages of Japanese summer, but don’t want to pressure your friends into plant-sitting, you can easily make your own automatic plant-waterer with an old shoelace. Simply put a container of water next to your plant and run your shoelace from the water to the plant pot. Raise the water container so that it’s higher than the plant pot and let capillary action do the rest. And voila! A slow, steady supply of water for your precious plant friends. Be careful, though, the water will drip from the lowest point of the lace, so make sure it doesn’t sag in the middle. If you don’t want to mess up your laces, or you have too many plants, you can substitute wool, cotton string, or anything else absorbent. More details here. […]

blog comments powered by Disqus

Related Supplies at Maker Shed