CRAFT Pattern: Splash Swimsuit Cover-Up

Craft & Design Yarncraft

Banner Craft Podcast
splashswimmymontage-lo.jpg
by Nikol Lohr
Cool, whisper-soft, and silky, this breezy lace cover-up is as comfortable to knit at the beach as it is to wear there. Worked in soft, gently luxuriant Lorna’s Laces Pearl, a 50/50 silk and bamboo blend, Splash knits up quickly with a simple old shale lace pattern that coaxes excellent mileage from the luxury yarn. (And yes, it’s named for the 80s mermaid-themed romantic comedy, but don’t feel pressured to wolf down a whole lobster or flop around in the bathtub when you wear it.)
splashdressymontage-lo.jpg
Worn over a simple cotton slip or sundress, it’s equally at home away from sun and sand. It’s fetching over a short slip that shows leg through the lace or over a longer sundress that peeks out from below the hem.
Splash is knit seamlessly from the top down, with increase rounds that widen the lace pattern along the shoulders every 4 repeats. The same swelling pattern is repeated along just the sides of the body for a subtle flare. The lace is softly clingy, with a gentle drape.

Download PDF Download the PDF | Subscribe in iTunes
Right click to save the PDF to your desktop. Directions on downloading PDFs.


Sizing Tips
Each of the two sizes fit a wide range. Bust measurement may have positive or negative ease depending on your size, as the soft, lacy fabric will drape elegantly over a smaller bust or expand willingly over a generous bustline. You can get a sense of the range of each of the two sizes from the two models: Charlene (blonde) wears a size 6 and measures 36-28-38, while I (brunette) wear a size 10-12 and measure 40-31-44. I also tested it with a padded push-up bra (taking me up to 43-inch bust) and the fit was still excellent and relaxed.
Do keep in mind that the wider your bust and hips, the shorter the dress will be on you. Also remember that silk knits often get longer over time. While this minidress won’t become a ball gown, it may creep closer to your knees with wear. Of course, the top-down design means you can frog any excess if you decide later on that you’d prefer it shorter.

Materials and Specs

Size
S/M (L/XL) Shown in S/M on both models.
About 32 inches long, with 32(40)-inch bust (stretches easily 8-10 inches larger than flat size)

Gauge
4 inches = 20 stitches in stockinette

Yarn
3(4) skeins Lorna’s Laces Pearl (50% silk, 50% bamboo; 220 yds/100g), shown in Fiddlehead

Notions
US 7/4.5mm 24-32-inch (60-80cm) circular needles
Stitch markers, including 1 contrast marker for end of rnd
Sharp darning needle
Locking stitch marker or safety pin

Pattern

Setup
CO 120. Join in the round and PM with the contrast marker.
Rnd 1: K24, PM, K36, PM, K24, PM, K36. This marks off the future sleeves.
Rnd 2: Purl.

Shoulders
Work next 4 rnds 3 times:
Rnd 1: *[K2tog] 2 times, [YO, K1] 4 times, [K2tog] 2 times, repeat from * to end.
Rnd 2-4: Knit.
Increase Set #1
Rnd 1: *[K2tog] 2 times, [YO, K1] 4 times, [K2tog] 2 times, repeat from * to end.
Rnd 2: Knit.
Rnd 3: *K3, [YO, K1] 6 times, K3, repeat from * to end.
Rnd 4: Knit.
Work next 4 rnds 3 times:
Rnd 1: *[K2tog] 3 times, [YO, K1] 6 times, [K2tog] 3 times, repeat from * to end.
Rnd 2-4: Knit.
Increase Set #2
Rnd 1: *[K2tog] 3 times, [YO, K1] 6 times, [K2tog] 3 times, repeat from * to end.
Rnd 2: Knit.
Rnd 3: *K6, [YO, K1] 6 times, K6, repeat from * to end.
Rnd 4: Knit.
Work next 4 rnds 3 times:
Rnd 1: *[K2tog] 4 times, [YO, K1] 8 times, [K2tog] 4 times, repeat from * to end.
Rnd 2-4: Knit.
Size S/M: Skip the rest of this section and jump to Sleeves.
Size L/XL only:
Increase Set #3
Rnd 1: *[K2tog] 4 times, [YO, K1] 8 times, [K2tog] 4 times, repeat from * to end.
Rnd 2: Knit.
Rnd 3: *K9, [YO, K1] 6 times, K9, repeat from * to end.
Rnd 4: Knit.
Work next 4 rnds 3 times:
Rnd 1: *[K2tog] 5 times, [YO, K1] 10 times, [K2tog] 5 times, repeat from * to end.
Rnd 2-4: Knit.

Sleeves
Note: The last patterned round you worked will be your main pattern round for the rest of the garment (Rnd 1, below).
Rnd 1: *[K2tog] 4(5) times, [YO, K1] 8(10) times, [K2tog] 4(5) times, repeat from * to end.
Rnd 2: Knit.
Rnd 3: Purl to first marker, knit to second marker, purl to third marker, knit to end.
Rnd 4: Knit.
Rnd 5 (Please review special instructions below before working): BO 48(60) stitches over sleeve, work next section to marker as for Rnd 1, repeat from * to end.
splashbo1-lo.jpg
Maintain your pattern alignment by BO the stitches above those earlier purled stitches.
To keep the pattern in line, make sure you BO only the stitches above those purl stitches from two rounds earlier. Don’t start by binding off the first stitch of the sleeve with the last stitch of the previous round – instead, work up to the marker and drop it, then knit 2 and BO the second stitch with the first (counting this as your first BO), then continue binding off, counting each stitch as you bind it off (not as you knit it).
splashbo2-lo.jpg
Your second-to-last BO will take you to this point, just over the last purl stitch (arrow). BO that last stitch as well…
splashbo3-lo.jpg
When you BO your last stitch, you’ll have BO all the sleeve stitches and your current live stitch will be sitting right over the first stitch of your pattern repeat (the first stitch not resting above a purl from two rounds back).
splashbo4-lo.jpg
To continue your pattern in alignment, slip that stitch back from the right needle to the left…
splashbo5-lo.jpg
… And proceed with the pattern from Rnd 1 (starting with a k2tog, working that slipped stitch together with its neighbor – the first three k2tog of the pattern are shown above). Work in pattern to the next marker and repeat process for the second sleeve.
Rnd 6: CO 12, PM, K to next sleeve, PM, CO 12, PM, Knit to end. PM for end.
Rnd 7: Knit
Rnd 8: P to first marker, K to next marker, P to next marker, K to end.

Body
You’ve set off two side panels (12 sts each) and front and back panels with your stitch markers. You’ll work the Shoulder pattern, complete with increase sections, within those side panels only, and the main pattern along the larger front and back sections. By the end of the shoulder increases, your patterns for both sections will be exactly the same, and from that point, you can drop your extra markers and work the main pattern for the whole thing.
splashflare-lo.jpg
Body with increases at sides:
Rnd 1: *[shoulder pattern], marker, [main pattern], marker, repeat from * to end.
Rnd 2: Knit.
Rnd 3: *[shoulder pattern], marker, knit to next marker, repeat from * to end.
Rnd 4: Knit.
Rnd 3 will be knit straight across on most rounds, but will also include an increase over just the side stitches every 4th set, as per the shoulder instructions. Once you’ve finished your last increase, drop the markers and work the main pattern all the way around.
Body after side increases:
Rnd 1: *[K2tog] 4(5) times, [YO, K1] 8(10) times, [K2tog] 4(5) times, repeat from * to end.
Rnd 2-4: Knit.
Finishing
After this point, figure out how much yarn you’re using per round. You can either do this by measuring out a set amount (start with 15 feet for a S/M or 20 for a M/L) and tying a slipknot in the yarn, then knitting a round to see how much less/more it uses up; or by knitting a round, tying a slipknot at the end, and frogging that round, then measuring what you used.
(I use the first method, loosely “measuring” the yarn by arms-lengths.)
As you approach the end of your last skein, measure out from the end enough for 4 rounds and tie a slipknot to flag it. Stick a locking stitch marker or safety pin through the loop for good measure. Keep an eye out for the flag. When you reach it (you can go up to a quarter rnd past it, but no further), if you need more to finish your current round, you should tink back to the end of your last round.
Purl one rnd.
Knit 1 rnd.
BO loosely.
Note: Garment will look shorter than expected. It will grow several inches longer after its bath.
Weave in ends. I like to weave in just enough to hold the ends in place, then use the special weaving technique below after blocking.
Soak in water, then press or spin out excess and spread on a flat surface block to a length of at least 32 inches (mine was 34 inches), measured from center neckline, and a width of 32(40) – 16(20) inches flat – at the bust.
If you need to adjust the shape of the scallops or remove the blocking crease after it’s dry, use a steam iron and a soft touch.
Special weaving technique
For slippery plied yarns and lace patterns, I like to use a special technique to weave in the ends securely without adding bulk. I find this is not only more delicate looking, but less apt to unravel.
Before blocking, weave in a quarter inch or so of each end – just enough to hold pattern in place – leaving long tails loose. You can skip the CO and BO ends entirely for now.
splashweave1-lo.jpg
Pull end taut. Note plied appearance.
splashweave2-lo.jpg
Twist yarn against the ply so that it unravels and the plies run fairly straight up and down (they’ll twist together again if you let go).
splashweave3-lo.jpg
Gently separate plies with a knitting needle or the blunt end of your darning needle.
splashweave4-lo.jpg
Using a sharp darning needle and working through yarn (splitting the yarn or sewing through it, not weaving around it), work in each ply as a separate end.
splashweave5-lo.jpg
Work each ply in a different direction to avoid building bulk, then snip end close to the fabric.

Wearing Variations

splash7-lo.jpg
If you prefer something firmer to the flexible, off-the-shoulder neckline, or if you just want an extra little decorative touch, weave a ribbon along the top edge and finish with an off-center bow.
splash11-lo.jpg
You can use the same technique under the bust or at the waist to add figure definition and a decorative touch. This example uses a wider ribbon, just the eyelets, and skips every other set.
splash10-lo.jpg
Wear over a longer dress with the skirt showing for a casual look, or over a shorter slip or sheath for a sexier cocktail look.

About the Author:
Author Nikollohr
Nikol Lohr lives at The Harveyville Project with her partner, 2 cats, 7 sheep, and 7 hens. She’s the author of Naughty Needles & founder of Yarn School. She blogs at The Thrifty Knitter, is cupcake on Ravelry, and queenievonsugarpants on Flickr.

Discuss this article with the rest of the community on our Discord server!
Tagged

ADVERTISEMENT

Escape to an island of imagination + innovation as Maker Faire Bay Area returns for its 16th iteration!

Prices Increase in....

Days
Hours
Minutes
Seconds
FEEDBACK