

Chocolate has to be one of my favorite build materials. It has a low melting point and hardens into a semi-rigid shapes when cooled down. Plus, it smells a heck of a lot better than ABS. If you’ve been waiting to make the move from PLA to Chocolate, your in luck. The Choc Creator chocolate printer will be made available later this year. It may cost twice as much as the competition, but then again you’re probably not going to want to eat a chunk of plastic. [via technabob]
4 thoughts on “Choc Creator Chocolate Printer”
Comments are closed.
So is the flavor good? Does the exposure to air while hot allow it to absorb odors and/or deteriorate (slash oxidize)?
[…] blog.makezine.com/2012/04/24/choc-creator-chocolate-printer/ […]