The Countdown to Maker Faire Bay Area is On!


Review: Smooth-On XTC-3D Brush-On Coating for 3D Printed Parts

3D Printing & Imaging Workshop
Review: Smooth-On XTC-3D Brush-On Coating for 3D Printed Parts
The kit and my setup.

Sometimes 3D printed parts look interesting printed in lower resolutions with distinct layer lines. For example, the lines on a 3D printed scale model of a larger part to be CNC routed can represent a visible tool path in scale, but sometimes you want a smoother, more highly-finished part.

I have found that PLA is especially hard to sand with satisfactory results. ABS can be smoothed using solvents with some success, but both processes are time consuming and/or toxic. Smooth-On’s XTC-3D Brush-On Coating for 3D Printed Parts is a two-part epoxy coating that can take this digital artifacting away more easily.


I started out by hot-gluing my models to dowels stuck in a block of scrap foam, so the excess resin could drip off without gluing my parts to a surface after curing. Measuring and mixing came next: the mix ratio is two parts resin to one part hardener by volume, which is easy to measure in the included graduated cup. Smooth-On even threw in a mixing stick.

When working with epoxies, one should be careful to mix thoroughly for a minute or two with a flat-ended stick, making sure both parts are fully incorporated. Without proper measuring and mixing a full cure is questionable.

Note that I’m wearing gloves when working with epoxy.

Next, I applied the coating with the included foam brush, floating on a slightly heavier coat at the top of the model so it could slowly run down to the bottom as it started to set up. The material has about a ten-minute working time in volume, slightly longer in thin film. The Maker Media Lab is cold, so the epoxy reached sufficient temperature to cure rather slowly. Therefore, more of it ran off than I would have liked, and another coat was necessary to completely fill my unwanted texture. I waited until the first coat was cured, then used a one-inch chip brush for the second coat. It worked a little better than the foam brush (the bristles offered a little more control).

After an overnight cure, that second coat provided a glossy, smooth surface. I would recommend this product to Makers who want to remove texture from their 3D prints. It’s relatively inexpensive, easy to use, and effective.

4 thoughts on “Review: Smooth-On XTC-3D Brush-On Coating for 3D Printed Parts

  1. HCM says:

    Could they have come up with a worse name for this stuff? “XTC” makes it sound like it belongs in an adult shop.

    1. DreadPirateZed says:

      Nah – to me it just sounds like they’re trying to tell the difference between a lemon and a lime, pain and pleasure… and the church bells softly chime.

  2. Nouters says:

    < ??????.+ zeldadungeon+ *********….. < Now Go R­e­­a­d M­o­r­e


  3. MariaJCarlson says:

    Want Success.? Read this makezine’s article… Online Job Help

Comments are closed.

Discuss this article with the rest of the community on our Discord server!

Marty Marfin is Maker Media Lab Manager. Also a sculptor, designer/fabricator, a maker dad, an avid surfer and astronaut on Spaceship Earth.

View more articles by Marty Marfin
Maker Faire Bay Area 2023 - Mare Island, CA

Escape to an island of imagination + innovation as Maker Faire Bay Area returns for its 15th iteration!

Buy Tickets today! SAVE 15% and lock-in your preferred date(s).