These instructions are intended to make a cutter for expanded polystyrene foam sheets of 5cm thickness. The cutter is suitable for cutting wind turbine blade sections designed using the club cycom software. Only use to cut polystyrene foam since other materials (such as polyurethane foam) will give off toxic fumes. Link.
2 thoughts on “HOW TO make a hot wire cutter for polystyrene foam”
Comments are closed.
Thanks for sharing this fantastic post, My friend have purchased some polystyrene sheets and foam and does not find the way to cut them. But now after reading your post I will tell him how to make cutter for his polystyrene foam. Your all the articles are mind blowing. I love your website.
You did not remember to [url=http://mofact.org/wp-content/temp/]nike air max pas cher[/url] mention to [url=http://mofact.org/wp-content/temp/]nike air max pas cher[/url] provide Playlist. net, wherever it’s not actually perhaps necessary for someone to [url=http://mofact.org/wp-content/temp/]nike air max pas cher[/url] enroll and you may steady flow any kind of melody you would like.