I have always wanted some Aerogel, and I am not sure why? Maybe just to hold something that is 99.8% air, or to try and figure out something to make with it. NASA seems to have found some uses for the amazing stuff. They have been successful in collecting cosmic dust samples, and insulating the Mars Pathfinder rover.
Aerogel can be very expensive and the prices vary greatly across Internet. Recently I found a relatively low cost supplier. You can get granular samples from United Nuclear for as little as $5. If you purchase a sample and make something cool, don’t forget to post it in the MAKE Flickr photo pool. – Link
More information about Aerogel:
14 thoughts on “Aerogel – 99.8% air, 100% cool”
Comments are closed.
Make your own Silica Aerogel:
http://eetd.lbl.gov/ECS/aerogels/sa-making.html
united nuclear is an interesting site. apparently (though i havent researched this thoroughly), you can purchase stuff that is wildly illegal in most places. dunno how that works…
You won’t be able to purchase anything that’s illegal in the US from United Nuclear. They also know state laws and will not sell you something that’s illegal to ship or sell in the state where you live.
Specifically, the radioactive sources are tiny, and are of a quantity that the US Nuclear Regulatory Commission allows for sale without documentation.
So, yes you can buy some Polonium 210, the same stuff used to kill a Russian ex-spy, but no, you won’t be able to buy much of it. A fraction of a milligram.
HOW TO MAKE AEROGEL
SINGLE-STEP BASE
CATALYZED SILICA AEROGEL
This will produce an aerogel with a density of
approx. 0.08 g/cm3. The gel time should be 60-
120 minutes, depending on temperature.
Mix two solutions:
• Silica solution containing 50 mL of TEOS,
40 mL of ethanol
• Catalyst solution containing 35 mL of ethanol,
70 mL of water, 0.275 mL of 30% aqueous
ammonia, and 1.21 mL of 0.5 M ammonium
fluoride.
• Slowly add the catalyst solution to the silica
solution with stirring.
• Pour the mixture into an appropriate mold until
gelation.
TWO-STEP ACID-BASE
CATALYZED SILICA AEROGEL
This will produce an aerogel with a density of
approx. 0.08 g/cm3. The gel time should be 30-
90 minutes, depending on temperature.
Mix two solutions:
• Silica solution containing 50 mL of
precondensed silica (Silbond H-5, or
equivalent), 50mL of ethanol
• Catalyst solution containing 35 mL of ethanol,
75 mL of water, and 0.35 mL of 30% aqueous
ammonia.
• Slowly add the catalyst solution to the silica
solution with stirring.
• Pour the mixture into an appropriate mold until
gelation.
you also need to supercritical dry your gel…dnt forget that step all you scientist lol.
Part of the problem with silica aerogel production is supercritical drying. It requires enormous pressures to make it work. There is, however, some very promising work being with vanadium aerogels that don’t require supercritical drying.
Aerogel.org has a much more in-depth guide for making aerogels of different types and even how to build a supercritical dryer!
Recipes:
http://www.aerogel.org/?cat=41
Building a supercritical dryer:
http://www.aerogel.org/?cat=33