DIY: Lithium Polymer Battery Charger

DIY: Lithium Polymer Battery Charger

This DIY battery charger is based on a Lipo Charger designed by Scott Henion. This is a perfect charger for RC enthusiasts, and robot makers. Check out the website for a few more pictures and a schematic.

Learn how to make your own Lipo Charger

4 thoughts on “DIY: Lithium Polymer Battery Charger

  1. RocketGuy says:

    While I fully support the DIY ethos, and this looks cool, I just have to mention that one has to be *extremely* cautious when charging lipo batteries.

    Charging is the most dangerous mode for lipo’s, and must be done at the rate (volts and amps) specified by the manufacturer, or your house is likely to burn down.

    “what, from that little battery” you ask?

    Yes, thermite grenades are small too, and do the job just fine. Check the youtube videos out, some aren’t too impressive, others are “holy crap!” big. Also, it’s an intense fire that you’re not going to put out easily, similar to a phosphorus marine emergency flare(don’t ask how I know that). So since I’m now a Lipo user, I have the responsibility to put the little monsters into a fireproof box before I charge them. Ammo can works, just don’t short anything, that’s another big no-no. These batteries have huge power, treat them with the respect you would an armed bear.

  2. tshepang says:

    thiswwebsite is awsome

Comments are closed.

Discuss this article with the rest of the community on our Discord server!
Maker Faire Bay Area 2023 - Mare Island, CA

Escape to an island of imagination + innovation as Maker Faire Bay Area returns for its 15th iteration!

Buy Tickets today! SAVE 15% and lock-in your preferred date(s).