HOW TO – Make PCB’s with a laser printer

HOW TO – Make PCB’s with a laser printer

Here’s how to make printed circuit boards with a laser printer Link.

See previous PCB how-tos.

Also, check out our extremely thorough “Primer” in MAKE Volume 02. Subscribers can log in and read it now.

6 thoughts on “HOW TO – Make PCB’s with a laser printer

  1. screaminscott says:

    Ummmm.. did he say keep the iron pressed to the paper for 5 minutes?

    Perhaps he meant 5 SECONDS?

    I think that the paper would catch fire after more than a few second.

  2. rickster says:

    Besides using a laser printer, one should be able to make this type of etching mask using a photocopier as well, since it also prints with thermally set toners.

    I’m sure he is correct about ironing the transfer for 5 minutes. Paper handles being ironed just fine. With the iron’s temperature setting on “silk”, the iron will only get to about 150°C (300°F) – well below paper’s flash point of 233°C (451°F). That temperature should be enough to bond the toner to the copper. The paper may get a little brown, however, if the iron is left stationary too long, but it won’t ignite. Frankly I’d be more worried about melting the board’s plastic base.

  3. nhjnmhjm says:

    Your comment will be posted in the background and may take a few minutes to appear on th

Comments are closed.

Discuss this article with the rest of the community on our Discord server!

current: @adafruit - previous: MAKE, popular science, hackaday, engadget, fallon, braincraft ... howtoons, 2600...

View more articles by Phillip Torrone


Maker Faire Bay Area 2023 - Mare Island, CA

Escape to an island of imagination + innovation as Maker Faire Bay Area returns for its 15th iteration!

Buy Tickets today! SAVE 15% and lock-in your preferred date(s).