Voltoids: HOW TO – Make 5V from 1.5V

Technology
Voltoids: HOW TO – Make 5V from 1.5V

Frr7Nlvf0Chg74I.Medium
Nice project from the PopSci folks on instructables — how to take 1.5V to 5v, and of course jam it in an Altoids tin.

Yes, you read that project title right; this simple circuit will enable you to generate 5V DC from a single 1.5V DC AA battery. How can you pump 1.5V up to 5V, you ask? It’s simple with a little piece of electronic steroids from MAXIM IC.

The MAX1674 IC is a DC-to-DC step-up converter that can take in voltages as low as .7V and crank out a digital circuit enriching 5V. Or, for more finicky projects, the MAX1674 can also output 3.3V. A simple pin-selectable preset determines the output voltage.

There is one small caveat with this project, however. Whether a blessing or a curse, the MAX1674 generates a steady-state output current ranging between 180-420 mA. Therefore, high current projects involving motors won’t be able to benefit from this voltage amplifying circuit.

On the other hand, powering lightweight projects involving TTL/LS circuitry or LEDs are ideal applications for Voltoids. In fact, with such a low operating current, the MAX1674 is able to drive a 3.3V LED without the ubiquitous power-limiting resistor. All from a single 1.5V AA battery.

If this project seems beyond your talents, but the benefits of powering a digital circuit from a single 1.5V DC power source sounds enticing, you can opt to purchase a similar circuit from Spark Fun Electronics. Costing less than $10, this clever little device which is designed by Bodhilabs.com is housed discretely on the back of an AA battery holder.

Unfortunately, with this commercial product you are limited to a fixed 5V output and it isn’t housed in a cool Altoids tin. Enter Voltoids.

instructables : Weekly Project: Voltoids; or, How to Make 5V from 1.5V – Link.

2 thoughts on “Voltoids: HOW TO – Make 5V from 1.5V

  1. bicq says:

    It is not completely accurate. The VPack_PCB is an adjustable output booster converter. Replace the RF2 with a 200K potentiometer. You can change the output level any where between 2V and 9V. Read the datasheet. The Voltoid can only switch between 3.3V and 5V.

Comments are closed.

Discuss this article with the rest of the community on our Discord server!
Tagged

current: @adafruit - previous: MAKE, popular science, hackaday, engadget, fallon, braincraft ... howtoons, 2600...

View more articles by Phillip Torrone

ADVERTISEMENT

Maker Faire Bay Area 2023 - Mare Island, CA

Escape to an island of imagination + innovation as Maker Faire Bay Area returns for its 15th iteration!

Buy Tickets today! SAVE 15% and lock-in your preferred date(s).

FEEDBACK