This 3D Printed Telescope Is Powered by Raspberry Pi

3D Printing & Imaging Digital Fabrication Raspberry Pi Science
This 3D Printed Telescope Is Powered by Raspberry Pi
PiKon 3D Printed Telescope
The PiKon

The PiKon project is a low-cost telescope kit using 3D printed components, an off-the-shelf heating duct, some Meccano,ย and a Raspberry Pi camera with the lens removed.

Earlier thisย year at Maker Faire UK, we talked to Mark Wrigley about the PiKon telescope, and how he went about building the 3D printed, Raspberry Pi powered, telescope.

Based on the Newtonian design, with a 113mm (approx. 4.5″)ย primaryย mirror, the telescope dispenses with the traditional flat secondary mirror, placing the small (25mmร—25mm) Raspberry Pi camera board atย prime focus.

First light images from the prototype PiKon. The angle of view of the PiKon is about 1/4 degree, which is about half of the Moon. (Credit: Mark Wrigley)
First light images from the prototype PiKon. The angle of view of the PiKon is about 1/4 degree, about half the size of the moon. Photo byย Mark Wrigley

The PiKon telescope is now crowdfunding on Indiegogo, andย is roughly three quarters of theย way towards its funding target with just a few daysย still to run on the campaign.

Tagged

Alasdair Allan is a scientist, author, hacker and tinkerer, who is spending a lot of his time thinking about the Internet of Things. In the past he has mesh networked the Moscone Center, caused a U.S. Senate hearing, and contributed to the detection of what wasโ€”at the timeโ€”the most distant object yet discovered.

View more articles by Alasdair Allan
Discuss this article with the rest of the community on our Discord server!

ADVERTISEMENT

FEEDBACK