My first print! OK, this really isn’t my first print, it’s actually my second print. Not bad, huh? My first print was a “raft” that didn’t stick. I did a little research online and found that my temperature was probably too cold. I increased the temperature by about 15 Degrees C and it worked perfectly […]
Lets jump right in here. We’re getting close to the end! Start by attaching the motherboard and stepper driver boards to the right side of the CupCake CNC. Make sure to use the included plastic spacers to keep the electronics away from the wood. Now you can connect the four-pin Molex connectors from the power […]
Building the Plastruder isn’t too difficult, but it does take about two hours. I’m highlighting the general build process. You are going to want to follow the official directions carefully, double-checking everything. It’s not hard to build, but having a short, or other problem, can lead to disastrous results. I like how MakerBot Industries describes […]
It’s been a while since I last posted about my CupCake CNC build. OK, it’s been a really long time! Well I’m back on it, and I’m not stopping till it’s done. The good news is, we are on the home stretch. So let’s get back into the build by installing the X and Y […]
