Secondary arms act as part of the support structure for machines like the CEB Press.
Sketchup Model Additional Materials Required: Shaker Mount Shaker Motor Shaker Hammer and coupler 1" Pillow Block Bearings(2) 1/4"x2″ Bolt (1) 3/8"x2″ Bolts (4) 1/2"x2″ Bolts (2) 3/8" Lock Nuts (4) 1/2" Lock Nuts (2) 3/8" Washers (8) 3/8" Lock Washers (4) 1/2" Washers (4) 1/2" Lock Washers (4)
Sketchup Model Additional Materials Required: 1" Keyed Coupler 1/4"x 2" Bolt
Sketchup Model
Sketchup Model Additional Materials Required: Hinges (12) 1/2"x1″ Bolts (12) 1/2" Nuts (12) 1/2" Washers (12)
Hopper Support Model Grate Support Model Additional Materials Required: 3/4"x1.5" Bolts (2) 3/4" Nuts (2) Shaker Mount
We are restoring old table lamps we had so we can use them now.
Materials Needed: Steel: .25×2 Flat: 12" (1) – Controller Mount .25×3 Flat: 6"(1) Controller Mount Bottom Piece .25×6 Flat: 12" (1) Valve Mount .25×6 Flat: 15" (1) Controller Mount .125x29x13.5 Sheet (1) Dirt Keeper Plate .125x29x17.5 Sheet (1) Brick Holder Plate Sketchup Model
This guide explains the steps for: Leg Holders-Model Feet- Model Legs- Model Secondary Arms- Model Primary Arms- Left Primary Arm Model, Right Primary Arm Model Additional Materials Required: 3/4" Steel Nuts (14) 3/4"x1.5" Bolts (14)
Sketchup Model
This tree is nothing more than 10 RGB (red/green/blue) LEDs connected in parallel to an Arduino with an Ethernet Shield running a modified version of the cheerlights sketch.
These simple feet attach to OSE legs to keep a variety of machines stable.